Memorize Proximity Key Menu; Copy Transmitter Menu; Transmitter Replacement Menu - Jcm-Tech Manager+Dcs Bedienungsanleitung

5.7

Memorize Proximity Key Menu

By means of the keys
Menu/Proximity Key. Press
This message appears on screen:
By means of the keys
Press the key . The code is asked for on screen. Enter the
relevant code using the numerical keypad. Press the key
again to validate the code.
The channel will now be asked for. Enter the channel number
and validate by pressing the key
The Portable Programmer will then ask you to place the key
close to the Interface. Remember to put it inside the serigraphed
area at 4 cm or less away.
Once the Interface has correctly saved the key, a short beep will
sound indicating the validity of the save operation. This message
will now appear on screen
With the subsequent visual confirmation of the operation.
The Portable Programmer MANAGER+DCS will return to the
menu

5.8 Copy Transmitter Menu (*)

This function is recommended only for copying the code of a faulty transmit-
ter to a new one.
This menu is accessed via
Main Menu/Transmitter.
Once selected, press
will appear.
Press . Connect the transmitter to be copied and press
any of its buttons.
Press . Connect the new transmitter (to which the code
is to be copied) and press any of its buttons.
5.9

Transmitter Replacement Menu (*)

This function allows a transmitter that has been lost or stolen to be annulled and
the same code to be used without any need to go to the installation to annul the
lost code in the receiver. That is, a "replacement" is made with a new transmitter,
or you should select the Main
.
or select the menu
.
and the Copy Transmitter menu
53
General functions