Changing The Installation Channel - Jcm-Tech Manager+Dcs Bedienungsanleitung

MANAGER+DCS 3.0X I
Press again. The following message will appear:
Insert the transmitter into the transmitter connection adapter (see figure on page
6, no. 9) and press the button of the transmitter, or insert the card into the smart-
card connector (same figure, no. 10) or approach the key to the Proximity Key Inter-
face.
The confirmation of the operation will appear on the screen.
Followed by:
Once all of the transmitters have been stored, the Portable
Programmer will return to the position
Press to return to the menu:
Remember to store the installation again in the memory card and in the
memory cartridge in order to make the changes effective.

2.12 Changing the installation channel

Retrieve the installation as indicated in section 2.1 of this chapter.
From the menu:
Press . The installation will appear on the screen:
Press the and
will appear on the screen requesting the channel number
required for the installation. Enter the number by means of
the numerical keys. Press
The following message will appear:
Followed by:
keys simultaneously. A message
.
22