Retrieving An Installation; Modifying The Code Of A Transmitter, Smartcard Or Proximity Key - Jcm-Tech Manager+Dcs Bedienungsanleitung

The maintenance of an existing installation can include various operations, such as
enlarging the number of codes, changing one or more code numbers, cancelling
code numbers, and so on. To carry out this maintenance, the first and obligatory
step to be taken is the retrieval of the installation.

2.1 Retrieving an installation

Insert the Receiver memory card in the slot (see figure on page 6, nos. 4 or 5), or
the memory cartridge where the installation is stored. The following example is for
a Single-Channel Receiver memory card.
Connect the Portable Programmer and enter the password.
Press . The following menu will appear on the screen:
Using the or
to the receiver device being used, that is, Receiver, Mini-
A.C. Unit or Maxi-A.C. Unit. Press
The following menu will appear on the screen:
Press 1 or 2 depending on the type of memory to be used,
and the following screen will immediately appear.
Using the or
Press .
The following menu will reappear on the screen:
The installation is now stored in the internal memory of the Portable Programmer
and can therefore be handled.
2.2 Modifying the code of a transmitter, smartcard or
proximity key
From the menu:
Press . The installation will appear on the screen:
Using the or
and press .
Enter the new code by means of the numerical keys and press
will appear on the screen. The new code will be in the reserve state (R).
Remember to store the installation again in the memory card and in the
memory cartridge in order to make the changes effective.
Quick guide for the maintenance of installations
keys, locate the menu corresponding
.
keys, go to menu:
keys, select the code to be modified
13
. The new code