Modify A Code; Create A New Code; Delete A Code; Change The Password Of A Mini-A.c. Or Maxi-A.c. Installation Created With The Manager+Dcs - Jcm-Tech Manager+Dcs Bedienungsanleitung

Press . The following message will appear on the screen:

5.13.1 Modify a code

This function makes it possible to modify the code of an existing installation.
Go into the required position and press
digits, lower than 524286). Press

5.13.2 Create a new code

This function makes it possible to enter a new code in the installation.
In the case of a Receiver, press
digits and press
sition and simply press

5.13.3 Delete a code

This function makes it possible to delete an individual code in an installation.
Go into the required position. Press
The position is now vacant.
5.13.4 Change the password of a Mini-A.C. or Maxi-A.C. installation
created with the MANAGER+DCS
To change the password, proceed as follows:
Press and
firm the password by entering it again and pressing

5.13.5 Go to position

This function makes it possible to go directly to the required position.
Press and
required position. Press
5.13.6 Memorize "n" transmitters/Memorize "n" smartcards/Memorize
"n" keys
This function makes it possible to store the codes of an installation to n transmitters or
n smartcards. All of the positions stored automatically assume the status G (stored).
Go into the position from which the codes are to be stored to the transmitters or
smartcards
In the case of transmitters ...
Press and
Connect successively the transmitters to be stored and press any button on them. Press
on completing the process of connecting and pressing a button on each transmitter.
. In the case of a Mini-A.C. or a Maxi-A.C., go into a vacant po-
.
simultaneously. Enter the new password and press
simultaneously. Enter directly the number corresponding to the
.
simultaneously to store transmitters.
. Enter the new code (a number of six
.
and simultaneously. Enter the code of six
57
General functions
.
. Con-