Entering Reserve Codes - Jcm-Tech Manager+Dcs Bedienungsanleitung

2.11 Entering reserve codes

Retrieve the installation as indicated in section 2.1 of this chapter.
From the menu:
Press . The installation will appear on the screen:
Using the or
smartcards.
Press the and
appear on the screen of the Portable Programmer asking
how many codes are to be reserved and in what manner,
sequentially or at random.
If you press , will indicate the maximum number of codes
available that are not reserved and will ask how many codes
you wish to reserve. Enter the quantity by means of the nu-
merical keys and press
It will then ask which channel is to be used.
If you wish to create a Mini-A.C. or Maxi-A.C. installation,
see the section on "Reserve Codes" in chapter 5 (General
functions).
Select the channel by means of the numerical keys and
press . The following message will appear momentarily:
Followed by:
The screen now shows the position of each transmitter, the code, the replacement
number, the status and the channel.
If you now wish to store the transmitters, smartcards or
proximity keys with the code numbers thus generated,
press the and
the transmitters, or
cards or proximity keys.
Select the quantity by means of the numerical keys (e.g. 3).
Quick guide for the maintenance of installations
keys, enter the position from which you wish to read the
keys simultaneously. A message will
.
keys simultaneously to store them in
and to store them in the smart-
21