General Considerations - Jcm-Tech Manager+Dcs Bedienungsanleitung

The MANAGER+DCS Portable Programmer allows the complete management of
installations, programming of transmitters, receiver or Access Control memories
and direct programming of smartcards and proximity keys. It is a powerful tool for
the installer.
It can incorporate a secret installer code, transferable to the whole system, which
prevents intrusion and creates customer loyalty. It also includes a password which
the installer can change at will and which protects the system in the event of unau-
thorised handling.
It operates by way of a rotary menu and with fixed function keys, which make it
possible to read transmitter, smartcard codes and proximity keys, read receiver and
Access Control memories, store codes individually or in groups, generate reserve
codes, etc. All of the information can be saved in memory cartridges or transmitted
to a computer and stored on diskettes.
It has a numerical keyboard, an LCD screen, low consumption (1.5V batteries or
mains power unit), and an automatic switch-off function for battery saving.

1.1 General considerations

Ensure that the receiver device is switched off at the mains before per-
forming any operation with the memory elements.
If working simultaneously with transmitters, smartcards and proximity keys,
avoid having them inserted in the Portable Programmer at the same time. This could
cause errors.
In order to work with the Portable Programmer, a memory cartridge must be in-
serted (see figure on page 6, no. 12).
If an erroneous password is entered three times in succession, the Portable Pro-
grammer is deactivated. To reactivate it, leave it switched on for two minutes, after
whichtime it will emit a series of "beeps" and then request the password again.
The Portable Programmer always works in its internal memory. This means that
whenever any operation is performed with it, the results must always be saved in
the memory cartridge of the receiver, as otherwise all of the information would be
lost on switching off the programmer.
The autonomy period of the programmer on battery power is approximately 30
hours. When the battery level is low, the "low power" LED will light up (see figure
on page 6, no. 7), and the message "low battery" will appear on the screen. We
recommend replacing the batteries at this moment, as otherwise the MAN-
AGER+DCS could induce errors.
The Portable Programmer has an automatic switch-off function: if no operation is
performed for five minutes, it will emit a series of "beeps" before switching off
automatically. While it is emitting this warning, if any key is pressed, it will return to
the normal "on" state.
5
Introduction