Direct Functions For Reading Or Storing A Transmitter; Smartcard Or Proximity Key - Jcm-Tech Manager+Dcs Bedienungsanleitung

Access is made by means of SmartCard Menu/Substitute.
Once selected, press
appear on the screen.
Press . Enter the number of the replacement to be
made.
Press once more. Insert the card you wish to include.
Then the following screens will ap-
pear
5.11 Key Replacement Menu
This function allows a proximity key that has been lost or stolen to be annulled and
the same code to be used without any need to go to the installation to annul the
lost code in the receiver. That is, a "replacement" is made with a new proximity key,
modifying the code and the "Replacement Number". This "Replacement Number"
goes from "0" to "3", so the original key may only have three replacements. A
higher replacement, on issuing the code to the receiver, annuls the previous one
and is automatically updated.
Access is made by Prox. Key Menu/Substitute.
Once selected, press
appear on the screen.
Press . Enter the number of the replacement to be
made.
Press again. Now the channel is requested. Enter the
channel number and validate by pressing the key
Then the Portable programmer will ask you to approach the
key to the Interface. Remember to approach it to the serigra-
phed areas and at a distance of less than 4 cm.
Once the Interface has saved correctly, a short beep will be emit-
ted to indicate the validity of the storing operation. The following
message will appear on screen
The operation will then be confirmed on screen

5.12 Direct functions for reading or storing a transmitter,

smartcard or proximity key (*)

These functions make it possible to read or store a transmitter, smartcard or prox-
imity key quickly and without having to enter any menu.
and the message type code will
and the message type code will
55
General functions
. .