Generating The Code Of The Transmitter In The; Installing A Receiver, Mini-A.c. Unit Or Maxi-A.c. Unit - Jcm-Tech Manager+Dcs Bedienungsanleitung

3.1.2 Generating the code of the transmitter in the Portable Pro-
grammer and storing in the transmitter
• Installing a Receiver, Mini-A.C. Unit o Maxi-A.C. Unit
Always select the menu corresponding to the receiver element being used
If the type of receiver element to be used is, for example, a Mi-
cro-Receiver, a Single-Channel Receiver or a Control Panel
Receiver Card, select the Receiver menu.
Press . The screen will show
Press 1 or 2 depending on the type of memory you are go-
ing to use. Once selected, press
will appear on the screen.
Press again. The following message will appear:
Press the and
appear on the screen of the Portable Programmer asking
how many codes are to be reserved and in what manner,
sequentially or at random.
If you press , the programmer will immediately ask how
many codes are to be reserved. Enter the quantity by
means of the numerical keys and press
If you wish to make a Mini-Exchange or Maxi-Exchange installation, see the section
on "Reserve Codes" in chapter 5 (General functions).
The programmer will then ask which channel is to be used.
Indicate the channel by means of the numerical keys and
press The following message will appear momentarily:
.
Followed by:
The screen now shows the position of each transmitter, the code, the replacement
number, the status and the channel. Pressing the
ternates the status between G and R.
. The Receiver Menu
keys simultaneously. A message will
37
.
and keys simultaneously al-
Creating installations