jcm-tech MANAGER+DCS Bedienungsanleitung Seite 151

Press . The installation will appear on the screen:
Using the or
smartcards.
Press the and
will show:
Press and a message will appear on the screen re-
questing the number of smartcards to be read. Enter the
quantity by means of the numerical keys. Press
The following message will appear:
Insert the card into the smartcard connector (see figure on page 6, no. 10).
The confirmation of the operation will appear on the screen.
Press for the programme to request the introduction of
another smartcard.
If we try to enter a transmitter twice, the following message
will appear:
Once all of the smartcards have been entered, the screen will show the position of
each card, the code, the replacement number, the status and the channel.
Press to return to the menu:
Remember to store the installation again in the memory card and in the
memory cartridge in order to make the changes effective.
Quick guide for the maintenance of installations
keys, enter the position from which you wish to read the
keys simultaneously. The screen
17
.