Change Status; New Installation - Jcm-Tech Manager+Dcs Bedienungsanleitung

MANAGER+DCS 3.0X I
In the case of smartcards or proximity keys ...
Press and
Select 1 or 2 depending on whether it is a card or a key. Enter the number that cor-
responds to the quantity you wish to store. Press
Successively insert the smartcards or proximity keys that you wish to store and
press after each one.
5.13.7 Read "n" transmitters/Read "n" smartcard/Read "n" keys
This function makes it possible to read the codes of n transmitters or n smartcards
and register them in an installation.
All of the positions read automatically assume the status G (stored).
Go into a free position from which the transmitters or smartcards are to be read
(only in the case of a Mini-A.C. or Maxi-A.C.).
In the case of transmitters ...
Press and
Enter the number of transmitters to be read and press
Connect successively the transmitters to be read, and on each of them press the
button corresponding to the required working channel.
In the case of smartcards or proximity keys...
Press and
Select 1 or 2 depending on whether it is a card or a key. Enter the number that cor-
responds to the quantity you wish to store. Press
Successively insert the smartcards or proximity keys that you wish to store and
press after each one.

5.13.8 Change status

This function makes it possible to change the status of a position.
Go into the required position.
Press and
opposite status.

5.13.9 New installation

This function makes it possible to delete all of the installation contained in the
memory of the MANAGER+DCS and create a new one.
From any position of the installation, press
the action by pressing
simultaneously to store smartcards.
simultaneously to read transmitters.
simultaneously to read smartcards.
simultaneously. The position will automatically change to the
.
.
.
.
and
58
simultaneously. Confirm