Change Type Of Memory Card; Protect Access To Memory - Jcm-Tech Manager+Dcs Bedienungsanleitung

MANAGER+DCS 3.0X I
Select Main Menu/Receiver,
Main Menu/Mini A.C. Unit...
...or Main Menu/Maxi A.C. Unit, and press .
Select Restore Instal. and press .
Select the number of the sector where the installation is located. Press .
Then select the number of the installation and press again.
Select Edit and press to work in the installation restored.

5.18 Change type of memory card

This function is accessed via:
Main Menu/Mini A.C. Unit...
...or Main Menu/Maxi A.C. Unit.
It enables the contents of the memory of a unit with a smaller code storage capac-
ity to be transferred to a unit with a larger memory. For example, the contents of a
Receiver can be transferred to a Mini A.C., or those of a Mini A.C. to a Maxi A.C.
Example:
To perform the process, let us assume that the source unit is a Receiver and the
destination unit is a Mini A.C.
Connect the memory card of the unit to be enlarged (Receiver) to the memory card
connector (see figure on page 6, no. 4).
Select the menu of the unit to which the contents of the source unit are to be trans-
ferred (in this case, a Mini A.C.: Mini Unit Menu).
Select Change TM type and press .
Select Edit and press to go into the new enlarged
installation.

5.19 Protect access to memory

62