Connection System - Jcm-Tech Manager+Dcs Bedienungsanleitung

The MANAGER+DCS Portable Programmer can be connected to IBM-compatible
PCs by means of a DB9-DB25 (male-female) RS-232 series cable.
4.1 Connection software
The software package, which enables the data of the MANAGER+DCS to be proc-
essed from the PC, is called SOFTMAN and can be obtained from your usual dis-
tributor.
4.1.1 Minimum requirements
G
PC Pentium 133 MHZ.
G
16 Mb of RAM memory.
G
10 Mb of free space on hard disk.
G
One free serial port RS232.
G
VGA Graphic card (recommendable 800 x 600).
G
CD-ROM Unit.
G
Printer (highly recommendable).

4.2 Connection system

Connect the wide end (25 pins) of the RS-232 cable to the appropriate serial port of
the computer and the narrow end (9 pins) to the PC connector of the MAN-
AGER+DCS Portable Programmer (see figure on page 6, no. 11).
Switch on the MANAGER+DCS and enter the password (remembering that the factory
setting is 000000). Now press the
AGER+DCS Portable Programmer is immediately connected to the computer.
and keys simultaneously. The MAN-
47
Connection to PC