Reserve Codes; Change Channel; To Change The Channel Individually To A Position; To Change The Channel To A Complete Installation - Jcm-Tech Manager+Dcs Bedienungsanleitung

5.13.10 Reserve codes

This function makes it possible to store reserve codes in an installation.
All of the positions will automatically assume the status R (reserved).
Go into a free position (only in the case of a Mini-A.C. or Maxi-A.C.). Press
simultaneously.
Select sequential or random codes
1= sequential
2= random
Press . Enter the number of reserve codes to be generated. Press
If sequential codes have been selected, the MANAGER+DCS will request the entry
of an initial code (6 figures). Enter the code and press
Only in the event that the unit operates in single-channel mode, enter the number
of the channel to be stored, and press
In the case of a Maxi-A.C., the MANAGER+DCS will ask if zonal mode is required.
If it is, enter the common channels that use the positions generated and press
If zonal mode is not required, press

5.13.11 Change channel

This function makes it possible to change the assigned channel individually to one
single position or to a complete installation.

• To change the channel individually to a position

Go into the required position. Press
quired channel number is reached. Press

• To change the channel to a complete installation

From any position, press
number and press

5.13.12 Configure codes in zonal mode

(Only from the Maxi-A.C. menu)
This function makes it possible to modify the channels assigned in zonal mode in
each position.
Go into the required position. Press
By means of the numerical keyboard, select or cancel the channels assigned in
zonal mode by entering the corresponding channel number, and press
In these cases, the screen display will be as follows:
directly.
and simultaneously. Enter the required channel
.
and
.
.
and or simultaneously until the re-
.
simultaneously.
59
General functions
and
again.
.
.