jcm-tech MANAGER+DCS Bedienungsanleitung Seite 172

MANAGER+DCS 3.0X I
To store the transmitters or smartcards with the code num-
bers thus generated, press
Enter the quantity by means of the numerical keys (e.g. 3).
Press again. The following message will appear:
Insert the transmitter into the transmitter connection adapter (see figure on page
6, no. 9) and press any button of the transmitter.
The confirmation of the operation will appear on the
screen:
Followed by:
Once all of the transmitters have been stored, the Portable
Programmer will return to the position:
Press to return to the Receiver Menu.
Now save the installation in the receiver memory card and in the memory car-
tridge, otherwise all of the information will be lost when the Portable Programmer
is switched off.
Using the or
Press . The following message will appear:
If the installation is a Mini-A.C. or a Maxi-A.C., a message
will appear requesting the password of the memory card.
Remember that you can change the default password, if you prefer. See
the section "Changing the password of a Mini-A.C. or Maxi-A.C. installation
created with the MANAGER+DCS" in chapter 5.
Enter the password by means of the numerical keys and press
A message will appear indicating the password number
.
previously selected:
and
keys, locate the menu:
simultaneously.
38