Installing A Maxi-A.c. Unit - Jcm-Tech Manager+Dcs Bedienungsanleitung

Switch off the power supply of the Portable Programmer, remove the memory card
and insert it correctly in the receiver (remembering that this must be switched off).
The installation is complete.
It is very important to note down the installation number and the sector of
the memory cartridge where it has been stored, together with the position
number and the code of each transmitter, in order subsequently to be able
to maintain the installation efficiently.

• Installing a Maxi-A.C. Unit

If the type of receiver element to be used is a Maxi-A.C.,
select the Maxi-A.C. Unit menu.
Once selected, press
appear on the screen:
Using the or
Press . A message will appear requesting the password
of the memory card of the Maxi-A.C.
Enter the password by means of the numerical keys and
press The following message will appear:
.
The Programmer will now return to the menu:
We recommend making a reservation of codes in the memory card of the
Maxi-A.C., in order to be able to store transmitters or smartcards without
having to go to the place where the receiver element is installed. For more
information, see the chapter on General functions.
In order to save a copy of the installation in the memory
cartridge, use the
Press . The following message will appear:
Using the or
to be saved. If another installation is already saved in this sector, the Portable
Programmer will indicate this on the screen by means of the abbreviations Rc if it
is a receiver installation, Mn if it is a Maxi-A.C., or Mx if it is a Maxi-A.C.
Press to access the screen that enables the selection
of the installation number where the installation being con-
figured is to be stored. This number can be selected by us-
ing the or
If the number is already occupied, it will be accompanied by the
symbol #. In this case, you must decide whether to overwrite the
previously stored installation or select a different number.
. The Maxi Unit Menu/Edit will
keys, locate the menu:
or keys to locate the menu:
keys, select the number of the sector where the installation is
keys.
43
Creating installations