LFP Cubic
Parameter
Info
FrmVer
SerNo
CalSta
TagNam
SigQua
SigQa1
SigQa2
SigQa3
StEcho
PASSW
8014825/YE12/2014-09-15 © SICK AG • Level sensors • Germany • Subject to change without notice
6 Menu overview
Description
Sensor information
Shows the firmware version
Shows the serial number
Displays the status of the container calibration
Initia = Container calibration not carried out
●
Calibr = Container calibration activated
●
Only shown if password entered.
Measuring point name, can only be described via IO-Link
Parameter describes the quality of the measuring signal.
See Chapter "5.6 Evaluating signal quality"
See Chapter "5.6 Evaluating signal quality"
See Chapter "5.6 Evaluating signal quality"
This function makes it possible to save diagnostic data in the device.
See Chapter "5.1 Expert mode"
EN
Operating instructions
97