Extraction Of Filter Cells In The Versions With Aspiration; Maintenance; Extraction Of Filter Cells In The Versions With Mobile Aspiration Panel - CLIVET ELFORoom2 003.0 Anleitung Zur Installation Und Wartung

7.1 GENERAL
Routine maintenance is indispensable to keep the cooler-
convector in perfect working condition, safe and reliable over
the years.
This can be done every six months for some interventions and
annually for others, by the Technical Service Assistance,
technically authorised and prepared, using always original
spare parts.
7.2 INSPECTIONS FREQUENCY
The inspections should be carried out at least:
•
Every year for only the cooling units
•
Every six months for the cooling and warming units
The frequency, however, depends on the use .
In the event of frequent use it is recommended to plan inspec-
tions at close intervals :
•
frequent use (continuous or very intermittent use, near the
operating limits, etc)
•
critical use (service necessary) .
7.3 CLEANING THE OUTSIDE
Before every cleaning
disconnect the appliance from the mains by switching off the
master switch.
Wait until the parts have cooled down to avoid the risk of
burns.
When necessary, clean the outer surfaces of the cooler-
convector with a soft cloth damp cloth.
Do not use abrasive sponges or abrasive or corrosive
detergents to avoid damaging the painted surfaces.
7.4 Extraction of filter cells in the versions with
aspiration
•
extract the front grill by lifting it slightly ( ref.A) and turn it
until it comes right out of its seat (fig. 7.1 rif. B) ;
•
extract the filter ( ref. C), pulling it horizontally outwards
(fig. 7.1 rif. D).
fig 7.1
81

7 - MAINTENANCE

and maintenance intervention,
7.5 Extraction of filter cells in the versions with mobile
aspiration panel
•
Insert your hands under the end of mobile panel
•
Press the plastic lug B
•
Lift and extract the mobile panel C
•
Extract the filter D
fig 7.2
7.6 Cleaning filtering seats
•
Suck up the powder with a vacuum cleaner ( ig. 7.3 rif. A)
•
Wash the filter (fig. 7.3 ref. B) with running water without
using detergents or solvents, and leave to dry.
•
Remount the filter on the cooler-convector (fig. 7.4 ref. A),
taking care to insert the lower flap (fig. 7.4 ref. B) into its
seat (fig. 7.4 ref. C)
•
It is forbidden to use the unit without the net filters.
•
The appliance is fitted with a safety switch that prevents
the operation of the cooler with the mobile panel missing or
out of position.
•
After finishing the cleaning of the filter, check that the panel
is mounted correctly.
fig 7.3