Built-In Electronic Thermostat; Control - CLIVET ELFORoom2 003.0 Anleitung Zur Installation Und Wartung

6.1 BUILT-IN ELECTRONIC THERMOSTAT

display
A
Automatic function
Silent function
Maximum ventilation speed
Night function
Heating
Cooling
Active supervision (flashing, see p.77)
Active alarm (Fixed on)
ON / Standby
Keep the ON standby button pressed for about 2 seconds.
The lack of a warning light indicates the "stand-by" status (no
function).
When the control is set to this operating mode it guarantees an
anti-freeze security.
If the room temperature falls below 5°C the boiler condensation
and hot water solenoid valves are activated.
AUTO automatic regulation of the ventilation speed
Press and hold the AUTO key.
When the function is activated, the relative symbol on the
display turns on
The ventilation speed is adjusted automatically between a
minimum value and a maximum value, according to the actual
gap between the ambient temperature and the selected
setpoint based on a PI algorithm.

6 - CONTROL

display
AUTO Automatic regulation of the ventilation speed
Use the two buttons to set the desired room temperature
which is displayed on the 3 digit display.
The adjustment range is from 16 to 28 °C; with resolution is
0.5 °C, but are also permitted off-scale values of 5 °C
and 40 °C.(except in AUTO mode)
Only set these values for short periods and then set the
selection to an intermediate value.
The command is very precise, set it to the desired value and
wait until the command has made the adjustment based on
the room temperature detected.
keys
keys
ON / Standby
Increase set temperature
Decrease set temperature
Night function
Minimum ventilation speed
Maximum ventilation speed
Heating / Cooling
temperature change set
72