CLIVET ELFORoom2 003.0 Anleitung Zur Installation Und Wartung Seite 76

Fan speed adjustment
By using the 4 keys, you can select the fan speed (automatic,
minimum, super silent and maximum).
When the function is activated, the relative symbol on the
display turns on.
The fan automatically performs a step-based adjustment as
the room temperature setpoint is gradually reached.
The supersilent speed will lead to strong dehumidification in
cooling and to radiant operation only (with fan off and solenoid
on) in heating.
By setting the top speed, one immediately obtains the
maximum deliverable power both in heating and cooling
mode.
Once the desired ambient temperature has been reached, we
recommend selecting one of the other 3 operating modes to
achieve greater thermal and acoustic comfort.
Temperature change set
Use the two buttons to set the desired room temperature
which is displayed on the 3 digit display.
The adjustment range is from 16 to 28°C, with resolution is 1 °
C, but are also permitted off-scale values of 5°C and 40°C
(except in AUTO mode)
Only set these values for short periods and then set the
selection to an intermediate value.
The command is very precise, set it to the desired value and
wait until the command has made the adjustment based on
the room temperature detected.
brightness reduction
After 20 seconds from the last action the panel brightness is
reduced on purpose to increase comfort at night and the
display shows the room temperature.
If the level of brightness still tends to cause a nuisance, it is
possible to turn off the display completely.
With the panel off, press and hold the + key for 5 seconds
until the message 01 appears.
With the - key, move the value to 00 and wait for 20 seconds
to verify the correct setting.
6 - CONTROL
By pressing the + and - Temperature keys together for 3
second, this activates the local block of all the keys.
This is confirmed by the fact that the word bL is displayed.
The user is prevented from using all the adjustments and
pressing any key and the display shows bL.
The keys are unlocked by repeating the sequence.
offset adjustment of ambient temperature probe
For use by the installer
The temperature probe is located in the bottom part of the
appliance, it may sometimes occur that the measurement
differs from the actual temperature.
Using this feature, you can adjust the measured value on the
display within a range of +/- 10°C in steps of 1°C
Use this setting with caution and only after verifying actual
room temperature deviations using a reliable instrument!
With the panel off, press and hold down the - key for 5
seconds and then enter the menu that allows you to vary the
AIR probe offset on the display (using the + and - keys) from
10 to +10 K in steps of 1 K.
After 20 seconds from the last action, the panel switches off
and the setting is memorised.
alarms
E1
Ambient temperature probe failure (AIR).
E2
Problem affecting the fan motor (for instance a jam due to
foreign bodies, a rotation sensor failure)
E3
Failure affecting the water temperature probe of the versions
with 2 pipes (H2) located in the main coil. (Check that the
installed probe is of the 10 k type)
keys lock
76