CLIVET ELFORoom2 003.0 Anleitung Zur Installation Und Wartung Seite 80

NIGHT FUNCTIONING
Press twice the ECO 2 button shortly : on the display will appear NGT (NIGHT)
See paragraph 6.4
Put the unit in MANUAL VENTILATION:
The fan speed self-adjusts itself, according to room temperature
MANUAL ventilation:
speed is decreased or increased by the user
The pressure of one of the two arrow keys deactivates the automatic ventilation.
The bar corresponding to the active speed flashes when ventilation is in manual mode
To restore the AUTOMATIC ventilation, perform the following:
-
increase speed to the maximum
-
another pressing will make the 8 bars flashing
-
if no other action is performed, the unit returns to automatic ventilation
If the function is managed remotely via ModBus, no modification can be performed (the word "REMOTE"
starts flashing)
SILENT
Pressing briefly the ON/OFF key and the silence mode is activated. Press the ON-OFF key again to
deactivate it. When silent mode is activated, the thermostat display shows the letters "SIL".
When the Set-changing keys are pressed, the first pressing displays the actual set instead of SIL.
After 10 sec. time-out, SIL is visualized if no keys that modify the set-point are pressed.
If the function is managed remotely via ModBus, no modification can be performed (the word "REMOTE"
starts flashing).
ALARMS
Before resetting an alarm, identify and remove its cause.
Repente resets can cause irreversible damage.
In case of doubt contact an authorized service centre.
The table shows all the variables that can be managed by the electronic system.
According to the machine configuration and its accessories, a few alarms can be meaningless.
Description
RES Active heater alarm
FES Active filter alarm
BT1 Air probe fault alarm
BT2 Water probe fault alarm
H2O Unsuitable water temperature alarm
EHH No communication / wrong thermostat connection
SYS Fault inside the control module
Mot fan motor sensor in alarm
6 - CONTROL
RESET
auto
SWING key
auto
auto
auto
auto
auto
auto
NGT
80