Preliminary Information; Reception; Positioning - CLIVET ELFORoom2 003.0 Anleitung Zur Installation Und Wartung

2.1 PRELIMINARY INFORMATION

General
Operate in compliance with safety regulations in force .
For detailed information (dimensions, weight, technical
characteristics etc.) please refer to the "Technical
information" section.
Use single protection devices : gloves, glasses ecc.
Stocking
Observe external packing instructions .
Handling
Verify unit weight and handling equipment lifting
capacity .
Identify critical points during handling (disconnected
routes, flights, steps, doors).
Verify the position of the barycentre in the Technical
information - DIMENSIONS section.
Before handling verify that the unit keeps its balance.
Packing removing
Be careful not to damage the unit.
Recycle and dispose of packing material in conformity
with local regulations.
2.2 DELIVERY CONTROL
Before accepting the delivery you have to check:
•
That the unit hasn't been damaged during tran-
sport.
•
Check that the materials delivered correspond
with that indicated on the transport document
comparing the data with the identification label
positioned on the packaging.
In case of damage or anomaly:
•
Write down on the transport document the da-
mage you found and quote this sentence:
"Conditional acceptance — clear evidence of
deficiencies/damages during transport".
•
Contact supplier and the carrier by fax and regi-
stered mail with advice of receipt.
Any disputes must be made within the 8 days following
the delivery. Complaints after this period are invalid.
2 - RECEPTION / 3 - POSITIONING
2.3 HANDLING
Do not leave loose packages during the transport
Do not handle the unit alone
Do not tramble

3 - POSITIONING

3.1 PRELIMINARY INFORMATION
General
Operate in compliance with safety regulations in force.
For detailed information (dimensions, weight, technical
characteristics etc.) please refer to the TECHNICAL
INFORMATION section.
Use single protection devices : gloves, glasses ecc.
During positioning consider these elements :
•
technical spaces required for the machine and system
•
place where the machine will be installed
•
electrical connections
•
water connections
•
air / aeraulic ducts
Do not considerer these elements could decrease
performances and operational life of the unit.
52