CLIVET ELFORoom2 003.0 Anleitung Zur Installation Und Wartung Seite 59

4.4.3 Coil rotation for connections on RIGHT
•
dismount the condensation collection tray (fig. 4.6 ref. A)
and remount it on the opposite side with the relative fixing
screws (fig. 4.6 ref. B).
•
loosen the four screws that fix the lower exchanger (fig.
4.7 ref. C);
•
remove the battery water probe;
•
remove the exchanger (fig. 4.7 ref. D);
•
remove the drip-collector extension from the central tray
(fig. 4.7 ref. E);
•
on the opposite side remove the cap on the condensation
evacuation hole (fig. 4.7 ref. F);
•
loosen the central condensation collection tray fixing
screw (fig. 4.7 ref. G), move the tray and rest it on the
fig 4.7
4.4.4 Motor connection kit cables (accessory KCMDX)
The cables are fed through the back of the device through the specific hole (ref.H)
The cable, equipped with male/female connectors, must be connected on the right side to the motor and on the left side to the quick
connector of the motor present on the board (ref.I).
Also, the two terminals from the grid safety microswitch must be extended and connected on the left side to contact S1 present on the
board (ref.L).
59
4 - WATER CONNECTIONS
INN-FR-B20
INN-FR-B30
opposite side so that the fixture mouth for the dripcollector
extension comes out of the structure, and block the tray with
the screw previously removed;
•
insert the drip-collector extension (fig. 4.7 ref. E) on the
opposite side (Right), check that is the correctly installed;
•
insert the cup (fig. 4.7 ref. F) on the opposite side (Left);
•
rotate the exchanger (fig. 4.7 ref. D) moving the fixtures to
the opposite side, and insert it on the machine;
•
insert the battery water probe;
•
tighten all the fixing screws of the exchanger
•
coat the connections with insulating material.
INN-FR-A10
INN-FR-B10