CLIVET ELFORoom2 003.0 Anleitung Zur Installation Und Wartung Seite 79

6.6 HID-T2 / T3 THERMOSTAT - OPTIONAL
Switch the thermostat ON
Hold down the ON OFF switch for 4 seconds
If the function is remotely managed via ModBus, it is not possible to perform any change (the word
"REMOTE" starts flashing)
Turn on/take off the anti-tampering block
Press the ECO + SWING buttons together for 5 seconds
The block is shown by 3 horizontal bars, when any key is pressed
If the function is managed remotely via ModBus, no modification can be performed (the word "REMOTE"
starts flashing)
Modify the set-point
Pressing on the arrows, the set-point increases or decreases (heating, ECO heating, cooling, ECO cooling).
The minimum difference between the two set points can not be lower than 1°C and the value is kept automa-
tically.
For example, if the unit is in cooling mode and the Summer set point is decreased so that it is close to the
Winter set point, the winter set point will be automatically lowered.
If the function is managed remotely via ModBus, no modification can be performed (the word "REMOTE"
starts flashing)
Display room temperature
Hold down on both arrows of the SET key; the room temperature is displayed, alternating with the letters
a".
Display room humidity
ONLY FOR HID-T3 THERMOSTAT WITH UR PROBE
Hold down on both arrows of the SET key, the room temperature is displayed, alternating with the letters "t a".
Hold down the Set key and the humidity value will appear, alternating with the letters "ur"
Go from HEATING mode to COOLING mode and vice versa.
If the unit is in manual mode, switching is performed by the relevant key
If the word "AUTO" is active on the display, the switching from one mode to another is managed automatically
by the unit and the pressing of this key has no effect.
If the function is managed remotely via ModBus, no modification can be performed (the word "REMOTE"
starts flashing)
Place the unit in ECO mode
Briefly press the ECO key
To restore normal operation, repeat the operation
The summer ECO set-point is higher than the SUMMER set-point, and the winter ECO set-point is lower than
the WINTER set point.
If the function is managed remotely via ModBus, no modification can be performed (the word "REMOTE"
starts flashing)
79
6 - CONTROL
set-point
unit in COOLING
unit in HEATING
eco MODE
visible if the cooling/heating mode choice is AUTOMATIC
unit is managed by NET
flashing : water temperature out of limits
(COOLING t>20°C, HEATING t<30°C)
"t