CLIVET ELFORoom2 003.0 Anleitung Zur Installation Und Wartung Seite 57

4.3.1 Condensation discharge HORIZONTAL version
To mount the horizontal bowl refer to the instructions in kits.
•
check that the "L" pipe and the flexible rubber hose are
correctly connected to the bowl (fig. 4.1 rif. A).
•
slide in the side of the machine keeping the pipe in
position up against the front grill.
•
fully close the side checking that the pipe remains blocked
in the special grove on the side (fig. 4.2 rif. B).
For the horizontal installation carefully note the following
precautions:
•
make sure that the machine is installed perfectly
level or with a slight inclination towards the
condensation discharge;
•
insulate carefully the inflow and outflow pipes up to
the machine union to prevent any drops of
condensation outside the same collection bowl;
•
insulate the bowl condensation discharge pipe
along all of its length.
fig 4.1
14ømm
fig 4.2
57
4 - WATER CONNECTIONS
4.3.2 Condensation discharge VERTICAL version
•
Connect to the condensation collection tray discharge
union (fig. 4.3 rif. A) a pipe for the outflow of the liquid (fig.
4.3 rif. B) blocking it adequately.
•
Check that the drip-collector extension (fig. 4.3 ref. C) is
present and correctly installed.
fig 4.3
4.4 FIXTURE ROTATION
The operations described and the relative images refer to a
machine with fixtures on the left on which the fixtures on the
right side must be rotated.
If there is a machine available with right side fixtures that
require rotation to the left, the sequence of the operations is
the same, only the images are a mirror image.
To connect the motor to the control kit, use the special
cabling optional.
4.4.1 Dismouting panels
•
Dismount the upper grill (fig. 4.4 ref. A) unscrewing the
two fixing screws (fig. 4.4 ref. B)
•
On the left-hand side lift the cover covering the screw (fig.
4.4 ref. C) and loosen the screw (D) that fixes the left
panel (fig. 4.4 ref. E) , then move it slightly to the left and
lift it up.
•
On the opposite side lift the cover covering the screw (fig.
4.4 ref. C) and unscrew it.
•
Move the side panel slightly (fig. 4.4 ref. F) to the right and
lift it.
•
Remove the lower front grill (fig. 4.5 rif. G).
•
Loosen the screws (fig. 4.5 ref. H-I) fixing the front panel
(fig. 4.5 ref. L) and dismount it.