Contax RTS II Gebrauchsanweisung Seite 10

l , ' r , : i , '
i - r W t ' ' l i
The main switch on top of the camera is used to turn the power
ON and OFF. Turn the switch as far as it will go in direction of
arrow (revealing a red dot for ON) to set the electronic shutter,
metering circuit, the viewfinder LEDs, etc in a state of readiness.
With the main switch turned on, pressing of the exposure check
button will cause the LED indicators in the viewfinder to light up
and stay on for 16 seconds. When the main switch is turned
back (red dot in covered position), all of the electrical circuits will
be turned off, causing camera functions to cease The LED
indicators will be turned off at the same time.
When not using the camera, make sure that the main switch
is turned OFF (red dot in covered position) to prevent
accidental activation of the exposure check or shutter release
button.
1B