Salmon Slide / Ls-Slide; Adjustment Of Ls-Slide - Graef Master 2720 Betriebsanleitung

4.4.2 Insert material to be cut (product) HS-Slide
• Hold the last slice device on the handle and pull it away from the blade up to end stop. (1)
• Swivel up the last slice device by 90° up to end stop. (2)
• Push the last slice device into the direction of the blade up to end stop.
• Now secure the last slice device against falling down. (3)
• Halve the product and cut it with a blade to required angle.
• +PUGTV QPG QT DQVJ JCNXGU QH VJG RTQFWEV VQ DG EWV UWEEGUUKXGN[ CPF Z KV D[ OGCPU QH VJG RTQFWEV UVTKR (4)
• Swivel the last slice device downwards and position it behind the product. (5)
• Adjust the product thickness and start cutting.
(2)
(1)
4.5.0

Salmon slide / LS-Slide

The angle is indicated concerning blade level. LS-Slide: 10 °-30°
6JG TGEQOOGPFGF VGORGTCVWTG QH VJG UJ KU YKVJKP VJG TCPIG QH Œ% DKU Œ%
The position of the hold-down spring can be adapted to the requirements of the customer, by unscrewing
and repositioning.
Attention!
Use (blue) screw lock while unscrewing!
4.5.1

Adjustment of LS-Slide

• Hold the handle of the blank holder and push it upwards, until it is unlocked. (1)
• Swivel the blank holder up towards the end stop by 90°. (2)
• Push the blank holder onto the bolt and thereby secure it against falling down. (3)
• Insert frozen product and secure against displacement by means of product strip.
• Swivel blank holder downwards and lock it.
r 6JG HTQ\GP UJ ECP DG CNUQ HGF KP HTQO DGJKPF YKVJQWV PGEGUUKV[ VQ QRGP VJG DNCPM JQNFGT (4)
3)
51
(4)
(5)