Removing The Docking Station; Standard Spare Parts - Viking MI 632 M Gebrauchsanleitung

Never place or store objects on the
robotic mower.
The temperature in the storage
room should not fall below 5°C.
Resuming operation of the robotic mower
following prolonged immobilisation:
The date and time may need to be
corrected following storage for a
long period. Appropriate selection
windows are displayed during initial
operation. If the selection windows
are not automatically displayed,
check the date and time in the
"TeaM settings" menu and correct if
necessary. ( 11.6)
● Prepare the mowing area:
Remove foreign objects and cut high
grass short using a conventional lawn
mower.
● Uncover the docking stations and
connect the power supply unit to the
mains supply
● Charge the battery ( 15.8)
● Check the mowing plan and change as
necessary. ( 10.)
● Switch on automatic mowing (
● If necessary, switch on GPS protection.
( 11.6)

16.9 Removing the docking station

The docking station can also be removed
if the robotic mower is to be stored for
long periods (e.g.winter break).
● Preparing the robotic mower for storage
for a long period ( 16.8)
● Disconnect the power supply unit plug
from the mains
0478 131 9937 B - EN
● Remove the docking station cover and
open the panel (
1 Fold open the left clamping lever (1).
2 Remove the left wire end (2) from the
terminal block.
Close the clamping lever (1) again.
3 Fold open the right clamping lever (3).
4 Remove the right wire end (4) from the
terminal block.
Close the clamping lever (3) again.
● Close the panel (
10.)
● Guide the left and right wire ends out of
the docking station separately from
each other
● Fit the docking station cover (
9.4)
Pull out the pegs (1), remove the docking
station (2) from the lawn with the power
supply unit connected, clean thoroughly
(with a moist cloth) and put into storage.
● Store the robotic mower together with
the docking station and the power
supply unit in the normal position and in
a dry, closed and dust-free room. Dock
the robotic mower in the docking
station. Make sure that the machine is
kept out of the reach of children.
9.4)
● Protect the terminals of the perimeter
wire from environmental influences
(e.g. wrap with suitable insulating tape).
● Reinstall the docking station in the
same way as during initial installation –
9.4)
in particular connect the right and left
perimeter wire ends on the correct
sides. (

17. Standard spare parts

Mowing blade:
6309 702 0102
9.10)
155