Viking MI 632 M Gebrauchsanleitung Seite 119

Fasten the perimeter wire (1) to the ground
on the left or right as appropriate, next to
the floor plate, directly next to a wire outlet,
using a fixing pin (2).
Provide a free wire end (1) with a length of
approx. 1.5 m.
Installing a mowing area:
0478 131 9937 B - EN
On side (A) of the master docking station
(1), route the perimeter wire (2) in a
straight line with a minimum clearance C
and at a right angle to the floor plate.
On side (B) of the master docking station
(1), route the perimeter wire (2) in a
straight line with a minimum clearance D
and at a right angle to the floor plate.
Then follow the edge of the mowing area
with the perimeter wire.
Minimum distance C: 1 m
Minimum distance D: 3 m
If offset drive home (passage) is
used, the perimeter wire must be
routed at least 1.5 m on both sides
of the master docking station in a
straight line and at right angles to
the floor plate. ( 11.8)
Route the perimeter wire (1) around the
mowing area and around any obstacles
( 12.6) and fasten it to the ground using
fixing pins (2).
A greater wire clearance must be
maintained at the corners around high
obstacles such as wall corners or high
flowerbeds X to prevent the robotic
mower from scraping against the obstacle.
Route the perimeter wire (1) in compliance
with the given clearances.
A = 27 cm
B = 10 cm
Avoid routing at acute angles (less than
90°). In acutely angled lawn corners,
fasten the perimeter wire (1) to the ground
with fixing pins (2) as illustrated.
117