Service Schedule; Handover Confirmation; Service Confirmation - Viking MI 632 M Gebrauchsanleitung

– Master docking station not connected to
mains supply – no LED illuminates
– Perimeter wire not connected to the
docking station – red LED flashes
( 13.)
– Break in perimeter wire – red LED
flashes ( 13.)
– Robotic mower and master docking
station not linked
– Electronics fault – LED flashes SOS
( 13.)
Remedy:
– Switch on the master docking station
( 13.)
– Check the power supply to the docking
station ( 9.10)
– Connect the perimeter wire to the
docking station ( 12.4)
– Search for wire break (
repair perimeter wire using wire
connectors ( 12.14)
– Link the robotic mower and docking
station ( 9.14) or assign a robot
mower to the iMow TeaM (
– Contact your specialist dealer ( )
Fault:
LED on the docking station flashes SOS
Possible cause:
– Minimum perimeter wire length not
reached
– Electronics fault
Remedy:
– Install the accessory (AKM 100) ( )
– Contact your specialist dealer ( )
Fault:
The robotic mower is not receiving any
GPS signal
Possible cause:
– The connection to the satellites is
currently being established
168
– 3 or fewer satellites within range
– The machine is in a dead spot
Remedy:
– No further action required; it can take a
few minutes for the connection to be
established
– Avoid or remove obstacles that might
be blocking the signal (e.g. trees,
canopies)
Fault:
The robotic mower cannot establish a
mobile radio connection
Possible cause:
– The mowing area is in a dead spot
– The radio module is not activated
Remedy:
16.7), then
– Have the radio module activated by a
VIKING specialist dealer ( )
Fault:
10.)
The robotic mower cannot be reached
using the app
Possible cause:
– Radio module inactive
– The robotic mower is in standby mode
– No Internet connection
– The robotic mower is not associated
with the correct e-mail address
– Robotic mower not assigned to an iMow
TeaM
Remedy:
– The radio module is switched off during
linking, then it is reactivated and the
robotic mower can be reached again
– Activate the robotic mower by pressing
a button
– Connect the machine on which the app
is installed to the Internet
– Correct the e-mail address (
– Assign a robotic mower to an iMow
TeaM ( 10.)

26. Service schedule

26.1 Handover confirmation

26.2 Service confirmation

Please hand this instruction manual
to your VIKING specialist dealer in
the case of maintenance work.
He will confirm the service operations
performed in the pre-printed boxes.
Service performed on
Next service date
10.)
2
0478 131 9937 B - EN