Installation Material - Viking MI 632 M Gebrauchsanleitung

Each docking station must not be inclined
by more than 2 cm rearwards or 8 cm
forwards. Never bend the floor plate. Any
unevenness must be removed under the
floor plate so that it fully contacts the
ground.
Installing the docking zone on a wall:
110
If the docking stations are installed on a
wall, a recess (1) must be made on the left
or right in the floor plate of the docking
stations using a pliers to make space for
the power cable (2).

9.3 Installation material

If the perimeter wire is not routed by the
specialist dealer, additional installation
material not included in the standard
equipment will be required to be able to
operate the robotic mower. (
The installation kits contain perimeter wire
on a reel (1) as well as fixing pins (2) and
wire connectors (3). The standard
equipment in the installation kits may
include additional parts not required for the
installation.
9.4 Docking station connections
Removing the cover:
18.)
Pull the cover (1) apart slightly on the left
and right as illustrated and remove
upwards.
0478 131 9937 B - EN