Team Installation - Viking MI 632 M Gebrauchsanleitung

Move the bar further to the
right for mowing at a lower
humidity. If the bar is moved
all the way to the right, the
robotic mower will only mow if
the rain sensor is completely dry.
2 Time:
Set the current time.
The set time must correspond to the
actual time in order to prevent inadvertent
mowing by the robotic mower.
The time can also be set using the
iMow app. ( 10.)
3 Date:
Set the current date.
The set date must correspond to the
actual calendar date in order to prevent
inadvertent operation of the robotic
mower.
The date can also be set using the
iMow app. ( 10.)
4 Track offset:
The robotic mower travels along the
perimeter wire at a 6 cm offset from
the wire as standard. With this offset,
optimum docking is ensured.
Recommendation:
The standard setting of 6 cm should
not be changed.
● Only if necessary, open the selection
window with OK and set the required
value (3 cm to 9 cm).
5 Language:
Set the required display language.
The language selected during initial
installation is set as the default.
0478 131 9937 B - EN

11.8 TeaM installation

1 Passage
2 ASM (anti-stuck manoeuvre)
3 New installation
4 Starting points
5 Edge testing
1 Passage:
Switch offset drive home on and off.
When the passage is activated, the robotic
mower travels back home to the docking
station, offset at a distance, along the
perimeter wire.
Three versions can be selected:
Off – Default setting
The robotic mower travels along the
perimeter wire.
Narrow – 40 cm
The robotic mower alternatively travels
along the perimeter wire or offset by
40 cm.
Wide – 40 - 80 cm
The distance to the perimeter wire is
selected randomly within this passage
during each drive home.
If offset drive home (passage) is to
be used, guide loops must be
installed. ( 12.10)
Staggered drive home can only be
activated when the perimeter wire
has been routed with a clearance of
at least 2 m at the narrowest
sections.
2 ASM (anti-stuck manoeuvre):
When ASM is switched on, the robotic
mower starts an evasive routine if it gets
stuck.
On – Default setting
Off – ASM should be switched off
– if the mowing area contains larger level
surfaces (e.g. asphalted drives),
– if the robotic mower often turns 90°
unexpectedly during the work,
– if the robotic mower remains stationary
with the message 1131 without getting
stuck during the work.
3 New installation:
The installation assistant is started
again, the existing mowing plan and
all settings for all machines grouped as an
iMow TeaM are deleted. ( 9.)
4 Starting points:
The robotic mower either starts the
mowing at the docking station where
the machine was charged (default setting)
or at a starting point.
Starting points are to be defined
– if partial areas are to be travelled to in a
targeted manner because they are
insufficiently mowed,
– if areas can only be accessed via a
corridor. At least one starting point must
be defined in these partial areas.
To set, either
● learn starting points
or
● select the required starting point and
define it manually.
Learning starting points:
Perform learning of the starting
points with one machine.
Make sure that all docking stations
are freely travellable.
131