Mowing Duration; Home Area; Manual Mowing; Operating The Machine - Viking MI 632 M Gebrauchsanleitung

14.4 Mowing duration

The mowing duration specifies how many
hours per week the lawn is to be mown. It
can be extended or reduced in the weekly
settings ( 10.).
The mowing duration corresponds to the
time during which the robotic mower mows
the lawn. Times during which the battery is
charged are not part of the mowing
duration.
During initial installation, the robotic
mower automatically calculates the
mowing duration based on the specified
size of the mowing area. This reference
value is based on a normal lawn under dry
conditions.
Mowing performance:
2
For 100 m , a robotic mower needs on
average:
MI 632 M:

14.5 Home area

The robotic mower identifies its location
using the built-in GPS receiver. During
each test run to check the correct wire
routing and when learning the starting
points, the robotic mower stores the
coordinates of the most westerly, easterly,
southerly and northerly point.
This area is defined as the home area and
the robotic mower can be used here. The
coordinates are updated each time a test
run is repeated.
When GPS protection is activated, the
owner of the machine is notified if the
machine is operated outside the home
area. The PIN code is also requested on
the robotic mower display.
146

14.6 Manual mowing

Do not activate the mowing blade or set
the lowest cutting height in high grass.
The robotic mower load must never cause
the mowing motor speed to drop
significantly. If the speed drops or the
robotic mower slows down, select a higher
cutting height setting.

15. Operating the machine

15.1 Preparation

An installation assistant is available
for initial installation. (
● Install the docking zone (
● Route the perimeter wire (
connect (
60 minutes
● Remove foreign bodies (e.g. toys, tools)
from the mowing area
● Charge the battery (
● Set the time and date (
● Check the mowing plan and adapt if
necessary using the iMow app – in
particular it must be ensured that third
parties keep away from the danger area
during active times. (
Mow very high grass until it is short
using a conventional lawn mower
prior to use of the robotic mower
(e.g. following a lengthy break).
9.)
9.1)
9.11) and
9.12)
15.8)
9.9)
10.)
15.2 Removing and installing the
control panel
The control panel can be removed from
the robotic mower as required in order to
perform manual mowing or to e.g. change
the programming.
Automatic operation of the robotic mower
is only possible when the control panel is
inserted.
Removing the control panel:
● In running operation, press the STOP
button before removing the control
panel.
Lift the rear of the control panel (1) with a
slight tug and remove it from the robotic
mower. It remains connected to the
machine via a spiral cable.
0478 131 9937 B - EN