Accurate Mowing Along Edges - Viking MI 632 M Gebrauchsanleitung

Guide loops with an external docking
zone:
To the right and left of the access to the
external docking zone, two guide loops (1)
have to be installed at an angle of 90° to
the perimeter wire.
Minimum clearance to access: 2 m
Guide loops with corridors:
142
Mowing area (A) and mowing area (B) are
linked by means of a corridor (1).
To the right and left of the corridor access,
two guide loops (2) have to be installed at
an angle of 90° to the perimeter wire.
These must always be located in the part
of the mowing area that can only be
accessed via a corridor.
Minimum clearance to corridor access:
2 m
If several consecutive corridors are
installed, guide loops must be
installed in each of the relevant
mowing areas.
Installation of a guide loop:
Guide loops must not be installed in the
vicinity of corners and corridors.
Note the minimum clearance to corners
and corridors: 2 m
Install the guide loop in the mowing area
as shown. The perimeter wire (1) must be
fastened to the ground with two fixing pins
at the edge A and must not be crossed.
Minimum length: 100 cm
Width: 1 cm
● Attach the guide loop to the ground with
a sufficient number of fixing pins.

12.11 Accurate mowing along edges

At a track offset of 6 cm, a strip with
a width of up to 20 cm is left
unmown along high obstacles. If
necessary, edging stones can be
laid around high obstacles.
Minimum width of edging stones:
0478 131 9937 B - EN