Finding A Wire Break - Viking MI 632 M Gebrauchsanleitung

Insert puller (I) into the carrier plate as
shown and turn anti-clockwise to the stop.
Support the machine with one hand.
Remove the carrier plate (1) by pulling on
the puller (I).
0478 131 9937 B - EN
Installing the carrier plate:
Thoroughly clean the blade shaft (1) and
the mounting on the carrier plate (2). Push
the carrier plate as far as possible onto the
blade shaft.
● Install the mowing blade. (

16.7 Finding a wire break

In the event of a wire break, the red
LED on the master docking station
flashes rapidly. ( 13.1) A
corresponding message appears in
the display of the robotic mower.
If a wire break cannot be found as
described, contact your specialist
dealer.
The wire break search can be performed
either with the control panel removed or
inserted. The control panel should be
inserted for the fine search.
● Before finding the wire break, the button
on the master docking station must be
pressed once (LED continues to flash
rapidly).
● Remove the master docking station
cover and open the panel. (
1 Fold open the left clamping lever (1).
2 Remove wire end (2) from the terminal
block and then close clamping lever again.
16.4) ● Close the panel and fit the master
docking station cover. (
The following instructions describe how to
search for a wire break in a clockwise
direction, i.e. the perimeter wire is followed
in a clockwise direction starting at the
master docking station. If necessary, the
search can also be carried out anti-
clockwise, but in this case the right wire
end must be removed from the terminal
block.
● Remove the control panel if necessary.
( 15.2)
● In the "Service" menu, select the "Find
wire break" entry and confirm OK.
( 11.14)
9.4)
9.4)
153