Viking MI 632 M Gebrauchsanleitung Seite 123

The perimeter wire must be routed
under the floor plate.
Lift the perimeter wire (1) max. 5 cm at the
required position. Position the docking
station (2) between the two pins (3) under
the perimeter wire (1). Release the
perimeter wire (1) and insert it in the cable
guide.
Install the docking station as described in
the "Fastening the master docking station
and connecting it to the mains supply"
section. ( 9.10)
Repeat this procedure for all the other
docking stations.
Then press the OK button on the
control panel.
0478 131 9937 B - EN
Connect the power supply unit plugs of the
master docking station and the other
docking stations to the mains supply.
Then press the OK button on the
control panel.
The LED indicator on the master
docking station lights up
continuously. ( 13.1)
The LED indicators of the
docking stations flash briefly
once, followed by a pause of about
8 seconds.
Place the robotic mower on which the
installation assistant is running in the
master docking station. As you do so, lift
the robotic mower slightly by the carrying
handle (1) and relieve the weight on the
drive wheels. Push the machine, resting
on its front wheels, into the master docking
station.
The LED indicator on the master
docking station flashes slowly after
docking. ( 13.1)
The LED indicators on the docking
stations continue to flash. (
Then press the OK button on the
control panel.
Only one robotic mower may be docked in
the master docking station.
13.2)
121