Viking MI 632 M Gebrauchsanleitung Seite 164

Message:
1140 – Too steep
Check wire routing
Possible cause:
– Tilt sensor has detected slope
inclination exceeding 22°
Remedy:
– Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 22°
Message:
1160 – Handle actuated
Press OK to release
Possible cause:
– The robotic mower has been lifted by
the carry handle
Remedy:
– Confirm message with OK
Message:
1170 – No signal
Check wire signal
Possible cause:
– No reception of wire signal during
operation
– The robotic mower is located outside
the mowing area
– Master docking station or electronic
components has/have been replaced
Remedy:
– Check the power supply to the master
docking station
– Check the LED indicator on the master
docking station ( 13.)
– Return the robotic mower to the mowing
area
– Link the robotic mowers and master
docking station ( 9.14)
162
Message:
1180 – Dock iMow
Automatic docking
not possible
Possible cause:
– The docking station was not found
– The start or end of a corridor was
installed incorrectly
Remedy:
– Check the LED on the docking station,
switch on the docking station if
necessary ( 13.)
– Check docking ( 15.7)
– Check funnel-shaped entrance and exit
areas of the corridor (
Message:
1190 – Docking error
Docking station occupied
Possible cause:
– All docking stations occupied
Remedy:
– Check whether the number of robotic
mowers matches the number of
docking stations.
Message:
1200 – Mowing motor fault
see message 0505
Message:
1210 – Drive motor fault
Wheel stuck
Possible cause:
– Overload at a drive wheel
Remedy:
– Clean the robotic mower (
– Level out any uneven areas (holes,
depressions) in the mowing area
Message:
1220 – Rain detected
Mowing interrupted
Possible cause:
– Mowing operation has been interrupted
or not started due to rain
Remedy:
– No action necessary; adjust rain sensor
if required (
Message:
1230 – Docking error
Dock iMow
12.8)
Possible cause:
– Docking station has been located,
automatic docking not possible
Remedy:
– Check docking, if necessary manually
dock robotic mower (
– Check perimeter wire – ensure correct
routing in the area of the docking station
( 12.3)
Message:
2000 – Signal problem
Dock iMow
Possible cause:
– Wire signal faulty, fine tuning necessary
Remedy:
– Place the master robotic mower in the
docking station – then press OK
16.2)
11.7)
15.7)
0478 131 9937 B - EN