Viking MI 632 M Gebrauchsanleitung Seite 166

Message:
2080 – Mains
No GPRS reception
Possible cause:
– No GPRS connection possible, the
mowing area is in a dead spot
Remedy:
– Contact a VIKING specialist dealer for a
detailed diagnosis
Message:
2090 – Radio module
Contact your specialist dealer
Possible cause:
– Communication with the radio module
interrupted
Remedy:
– No action required, firmware will be
automatically updated if necessary
– Contact your VIKING specialist dealer if
the problem persists
Message:
2095 – Radio module
Contact your specialist dealer
Possible cause:
– Communication with the GPS antenna
interrupted
Remedy:
– No action required, firmware will be
automatically updated if necessary
– Contact your VIKING specialist dealer if
the problem persists
164
Message:
2100 – GPS protect.
Outside home area
Machine disabled
Possible cause:
– The robotic mower was removed from
the home area
Remedy:
– Return the robotic mower to the home
area and enter the PIN code (
Message:
2120 – Child lock
Child lock active
Possible cause:
– Impact sensor triggered several times
consecutively
– Robotic mower has been lifted during
travel
Remedy:
– No action required – if the impact
sensor is not triggered again, the
message automatically becomes
inactive within max. 1 minute
– Deactivate the child lock (
Message:
2300 – Note
Initial installation running.
Data is being received.
Possible cause:
– Initial installation is being performed
with another robotic mower from the
iMow TeaM – after initial installation,
the data will be synchronised
Remedy:
– Complete the initial installation – the
message will then automatically
become inactive
Message:
4001 – Internal fault
Outside temperature range
Possible cause:
– Temperature in battery or inside the
machine too low or too high
Remedy:
– Allow the robotic mower to warm up or
cool down – observe permissible
5.10) temperature range of battery (
Message:
4002 – Rollover
see message 1000
Message:
4003 – Hood lifted
Check hood
Then press OK
Possible cause:
– Hood has been lifted
Remedy:
– Check the hood and confirm the
message with OK
11.9)
Message:
4004 – Internal fault
Press OK to release
Possible cause:
– Error in the programme sequence
– Power failure during automatic
operation
– Robotic mower is located outside the
mowing area
Remedy:
– Confirm message with OK
6.4)
0478 131 9937 B - EN