Viking MI 632 M Gebrauchsanleitung Seite 168

Fault:
The robotic mower is not working and
nothing is shown in the display
Possible cause:
– Machine is in standby
– Battery defective
Remedy:
– Press any button to wake up the robotic
mower – the status screen appears
( 11.2)
– Replace the battery ( )
Fault:
The robotic mower is noisy and vibrates
Possible cause:
– Mowing blade is damaged
– Mowing deck is very dirty
Remedy:
– Replace the mowing blade – remove
any obstacles from the lawn (
( )
– Clean the mowing deck (
Fault:
Poor mulching or mowing result
Possible cause:
– Grass is too high in relation to the
cutting height
– Lawn is extremely wet
– Mowing blade is blunt or worn
– Active times insufficient, mowing
duration too short
– Size of mowing area set incorrectly
– Mowing area with very high grass
– Long periods of rain
Remedy:
– Adjust the cutting height (
– Set the rain sensor ( 11.6)
Change the active times (
166
– Replace the mowing blade (
( )
– Extend or add active times (
Extend the mowing duration (
– Create a new mowing plan (
– For neat mowing results, the robotic
mower needs up to 2 weeks, depending
on the size of the mowing area.
– Allow mowing in the rain (adjust the rain
sensor) (
Extend the active times (
Fault:
Display in a foreign language
Possible cause:
– Language setting has been changed
Remedy:
– Set the language (TeaM settings)
( 11.6)
Fault:
16.4),
Brown (earthy) patches appear in the
mowing area
16.2)
Possible cause:
– Mowing duration is too long in relation
to the mowing area
– Perimeter wire has been routed with
excessively tight radii
– Size of mowing area set incorrectly
Remedy:
– Reduce the mowing duration (
– Correct the routing of the perimeter wire
( 9.11)
– Create a new mowing plan (
Fault:
Mowing operations are significantly
shorter than usual
9.8)
Possible cause:
10.) – Grass is very high or too wet
16.4),
10.)
10.)
10.)
11.6)
10.)
10.)
10.)
– Machine (mowing deck, drive wheels) is
very dirty
– Battery has reached end of service life
Remedy:
– Adjust the cutting height (
Set the rain sensor (TeaM settings)
( 11.6)
Change the active times (
– Clean the machine ( 16.2)
– Replace the battery – observe
corresponding recommendation on the
display ( ), ( 24.)
Fault:
The robotic mower is docked, the battery is
not charging
Possible cause:
– The battery does not need to be
charged
– Docking station not connected to power
supply
– Incorrect docking
– Charging contacts corroded
Remedy:
– No action necessary – battery charging
occurs automatically below a certain
voltage
– Check the power supply to the docking
station ( 9.5)
– Place the robotic mower in the mowing
area and send it back to the docking
station ( 10.), check for correct
docking – if necessary, correct the
position of the docking station (
– Replace the charging contacts ( )
Fault:
Docking not working
Possible cause:
– Uneven entry area to docking station
– Dirty drive wheels or dirty floor plate
0478 131 9937 B - EN
9.8)
10.)
9.2)