Connecting The Perimeter Wire; Confined Areas; No-Go Areas - Viking MI 632 M Gebrauchsanleitung

● Beginning at the master docking
station, route the perimeter wire around
the mowing area and any obstacles
( 12.6) and fasten it to the ground
using fixing pins.
Follow the instructions in the "Initial
installation" section. (
● Connect the perimeter wire. (

12.4 Connecting the perimeter wire

● Disconnect the mains plug
and then remove the master
docking station cover.
● Insert the perimeter wire into the cable
guides of the floor plate, guide it
through the socket, attach the
connector and connect to the master
docking station.
Follow the instructions in the "Initial
installation" section. (
● Install the master docking
station cover and then
connect the mains plug.
● Check the wire signal. (
● Check docking. ( 15.7)
If necessary, correct the position of the
perimeter wire in the area of the
docking zone.

12.5 Confined areas

If confined areas are to be installed,
switch off offset drive home
(passage) ( 11.8) or install guide
loops. ( 12.10)
The robotic mower travels automatically in
all confined areas, provided the minimum
wire clearance is maintained. The lawn is
mown automatically in these confined
138
areas.
Narrower areas of the mowing area must
be blocked off through appropriate routing
of the perimeter wire.
If two mowing areas are linked via a
narrow passage that can be travelled on, a
9.11)
corridor can also be installed. (
9.12) The lawn is not mown in corridors.
9.12)
Minimum wire clearance: 80 cm
This results in the following space
requirements in confined areas:
9.14)
– between high obstacles (> 2 cm – e.g.
walls, hedges):
134 cm
– obstacles that can be travelled on (≤
2 cm – e.g. paths, patios):
80 cm

12.6 No-go areas

No-go areas have to be installed
– around obstacles that the robotic
mower must not touch,
– around obstacles that are not
sufficiently sturdy,
– around obstacles that are too low.
Minimum height: 10 cm
We recommend
● blocking off obstacles by means of no-
go areas or removing them,
● checking no-go areas after initial
12.8)
installation or after changes to the wire
installation using the "Test edge"
command (TeaM settings menu).
( 11.)
Minimum clearance A from the no-go
area to the edge loop: 54 cm
0478 131 9937 B - EN