Docking Station Controls; Notes On Mowing; General; Mulching - Viking MI 632 M Gebrauchsanleitung

13.2 Docking station controls

A circular red LED (1) provides information
on the status of the docking station.
In contrast to the master docking station,
the button (2) has no function on the
docking station.
LED does not illuminate:
– Docking station disconnected from the
power supply.
LED flashes once, followed by a pause
of approx. 5 seconds:
– Docking station is active.
– Robotic mower is not docked.
LED flashes slowly (2 seconds on –
briefly off):
– Robotic mower is docked, battery is
charging.
– Docking station is active.
LED flashes rapidly:
– Error in the TeaM stick.
LED gives 3 short flashes, 3 long
flashes, 3 short flashes, followed by
approx. 5 second pause (SOS signal):
– Error in the docking station.
0478 131 9937 B - EN
Switching the docking station on
and off:
It is not possible to switch the
docking stations on and off by pressing the
button.
Homecall:
It is not possible to perform a
Homecall for the robotic mowers on
the docking stations.

14. Notes on mowing

14.1 General

The robotic mower is designed so that
multiple machines can automatically mow
a mowing area at the same time. The
grass is kept short through continuous
mowing. The result is a perfect, thick lawn.
Lawns that have not previously been
mown using a conventional lawn mower
will only be mown neatly following several
mowing operations. Especially in the case
of high grass, a good cutting pattern is only
achieved after a few mowing operations.
In hot, dry conditions, the lawn should not
be kept too short as it will otherwise be
burnt by the sun and become unsightly.
The cutting pattern will be better with a
sharp blade than with a blunt one; the
blade should therefore be replaced
regularly.

14.2 Mulching

The robotic mower is a mulching mower.
During mulching, the grass clippings are
further shredded in the mowing deck
housing after cutting. They then fall back
into the turf, where they remain and
decompose.
The finely shredded clippings return
organic nutrients to the lawn, serving as a
natural fertiliser. Fertiliser requirements
are thereby reduced significantly.

14.3 Active times

During the active times, the robotic mower
is allowed to leave the docking station and
mow the lawn. During these times,
mowing operations, charging
operations and rest periods take place.
The robotic mower automatically
distributes the mowing and charging
operations between the available time
windows.
During installation, active times are
automatically distributed over the entire
week. Time reserves are taken into
account – this ensures perfect lawn care,
even if individual mowing operations
cannot take place, (e.g. due to rain).
During the active times, third
parties must keep out of the danger
area. The active times should be
adapted accordingly.
Moreover, the applicable local
regulations on the use of robotic
mowers as well as the information
in the "For your safety" (
section must be observed and the
active times changed accordingly
using the iMow app. (
In particular, you should check the
times of the day and night at which
it is permissible to use the machine
with the responsible authorities.
6.)
10.)
145