Preparatory Measures - Viking MI 632 M Gebrauchsanleitung

Guide the power cable through the cable
guide (1) on the panel.
● Close the panel. ( 9.4)
Press the power cable into the cable
guide (1) as illustrated and guide through
the strain relief (2) and the cable duct (3)
to the power supply unit.
● Close the docking station cover. (
9.6 Notes on initial installation
Follow the sequence of the
instructions in the installation
assistant to ensure that the
synchronisation of the
programming of all machines in the
iMow TeaM works properly during
installation.
Before starting the installation
assistant on the machine, the
iMow app must be downloaded.
( 10.)
iMow app:
● Download the iMow app.
● Start the iMow app.
112
● Assign the machine to an iMow TeaM.
Run the installation assistant on the
machine:
Only start the installation assistant
on the machine used to perform the
installation. Activate all other
machines by pressing any key.
An installation assistant is
available for installation of the
robotic mower. This program
guides you through the entire
initial installation process:
● Set the language.
● Set the date and time.
● Note:
All machines must be grouped together
to form an iMow TeaM.
● Install the master docking station.
● Note:
Place all other docking stations outside
9.4)
the mowing area and connect them to
the mains. Activate the machines by
pressing any key and place them in the
docking stations. The battery is charged
during installation.
● Route the perimeter wire.
● Remove the TeaM stick on the master
docking station and connect the
perimeter wire.
● Install all other docking stations.
● Place the robotic mower in the master
docking station.
● Note:
Keep the remaining docking stations
free.
● Link the robotic mower and master
docking station.
● Check installation.
● Enter the mowing area.
● Confirm the mowing plan and active
times.
● Complete the initial installation.
The installation assistant must be worked
through in its entirety on a machine. Only
then is the iMow TeaM ready for operation.
After completion of the initial installation,
all machines assigned to the iMow TeaM
in the iMow app have the same values set.
An installation video is available
at the www.viking-garden.com
homepage.
Your specialist dealer can provide
you with further information on
installing the robotic mower.
The installation assistant is re-
activated following a reset (reset to
factory defaults). (

Preparatory measures:

● Mow the lawn using a conventional
lawn mower prior to initial installation
(ideal grass height of 3 to 4 cm).
● In the case of a hard and dry surface,
water the mowing area lightly in order to
make it easier to drive in the fixing pins.
● All machines in the iMow TeaM must be
activated by a specialist dealer and
assigned to the owner's e-mail address.
( 10.)
0478 131 9937 B - EN
11.14)