Planning Routing Of The Perimeter Wire; Making A Sketch Of The Mowing Area; Routing The Perimeter Wire - Viking MI 632 M Gebrauchsanleitung

12.1 Planning routing of the perimeter
wire
Study the installation examples at
the end of this instruction
manual. ( 27.)
Include no-go areas, corridors,
secondary areas, guide loops and
reserve wire during routing of the
perimeter wire, in order to prevent
subsequent corrections.
● Determine the location of the docking
zone ( 9.1)
● Either remove obstacles from the
mowing area, or include no-go
areas. ( 12.6)
● Perimeter wire:
The perimeter wire must be routed in a
continuous loop around the entire
mowing area.
Maximum length:
500 m
Minimum length:
70 m
For mowing areas < 40 m² and only
when the red LED on the docking
station signals SOS, the accessory
AKM 100 must be installed
together with the perimeter wire.
● Corridors and secondary areas:
For automatic mowing, join all parts of
the mowing area by means of
corridors. ( 12.8)
If there is insufficient space to do so,
secondary areas must be
installed. ( 12.7)
0478 131 9937 B - EN
● Observe the specified clearances
when routing the perimeter wire:
for obstacles that can be travelled on
(e.g. paths): 0 cm
for corridors: 80 cm
for high obstacles (e.g. walls, trees):
27 cm
minimum wire clearance in confined
areas: 80 cm
for water features and potential sudden
drops (edges, steps): 100 cm
● Corners:
Avoid routing at acute angles (less than
90°).
● Guide loops:
If offset drive home (passage) is to be
used, guide loops must be
installed. ( 12.10)
● Reserve wire:
Reserve wire should be installed at
several points to make it easier to
subsequently change the routing of the
perimeter wire. ( 12.13)
Coiled up residual pieces of
perimeter wire can cause
malfunctions and must be removed.
12.2 Making a sketch of the
mowing area
During installation of the robotic
mower and the docking zone, it is
recommendable to make a sketch of the
mowing area. A page has been provided at
the start of this instruction manual for this
purpose.
The sketch should be modified in the event
of subsequent changes.
Content of the sketch:
– Contour of the mowing area including
important obstacles, borders and any
no-go areas which the robotic mower
must not mow. (
– Position of the docking zone (
– Position of perimeter wire
After a short while, the perimeter wire is
overgrown and is no longer visible.
Make a note of the routing of the wire
around obstacles in particular. (
– Position of the wire connectors
After a short while, the wire connectors
used are no longer visible. Their
position should be noted in order to
replace them as required. (

12.3 Routing the perimeter wire

Only use original fixing pins and
original perimeter wire. Installation
kits with the necessary installation
material are available as an
accessory from the specialist
dealer. ( 18.)
The routing direction (clockwise or
counterclockwise) is freely
selectable according to
requirements.
Never pull out fixing pins using the
1
perimeter wire – always use a
suitable tool (e.g. universal pliers).
Make a sketch of the perimeter wire
routing. ( 12.2)
● Install the docking zone. (
27.)
9.1)
9.11)
12.14)
9.1)
137