Battery; Transporting The Machine; Before Initial Operation; Installing The Docking Station - Viking MI 422 Gebrauchsanleitung

Danger of electric shock!
Damaged cables, connectors and plugs,
or electric cables which do not conform
with regulations may not be used.
Always ensure that the power cables used
are adequately protected by a fuse.
Detach electric cables at the plug and
socket and not by pulling on the electric
cable.
Only connect the machine to a power
supply that is protected by means of a
residual current-operated protective
device with a release current of a
maximum of 30 mA. Your electrician can
provide further information.
If the power supply unit is connected to the
mains supply outside a building, the socket
must be approved for outdoor use. Your
electrician can provide further information
about country-specific legislation.
It must be noted that current fluctuations
can damage the machine when it is
connected to a power generator.

6.4 Battery

Only use original batteries.
The battery is intended exclusively for
fixed installation in a VIKING robotic
mower. There, it is optimally protected and
is charged when the robotic mower is in
the docking station. No other charger must
be used. The use of an unsuitable charger
can result in danger due to electric shock,
overheating or escaping corrosive battery
fluid.
Never open the battery.
Do not drop the battery.
Never use a defective or deformed battery.
0478 131 9923 B - EN
Store the battery out of the reach of
children.
Explosive hazard!
Protect the battery
against direct sunlight,
heat and fire – never
throw it into a fire.
Only use or store the battery at
temperatures from -10°C to max.
+50°C.
Protect the battery against rain
and moisture – do not immerse in
liquids.
Do not subject the battery to
microwaves or high pressure.
Never connect the battery terminals with
metallic objects (short-circuit). The battery
can be damaged through short circuits.
Keep the unused battery away from
metallic objects (e.g. nails, coins,
jewellery). Do not use metallic transport
containers – Explosive and fire hazard!
Fluid may escape from the battery due to
improper use – Avoid contact! In the case
of inadvertent contact, rinse with water.
Seek medical attention if the fluid contacts
the eyes. Escaping battery fluid can cause
skin irritation and burns.
Do not insert any objects in the ventilation
slots of the battery.
For further safety instructions, see
www.viking-garden.com/safety-data-
sheets

6.5 Transporting the machine

Before transporting, and especially before
lifting the robotic mower, activate the
disabling device. ( 5.2)
Allow the machine to cool down before
transporting.
Avoid contact with the mowing blade when
lifting and carrying the machine. The
robotic mower must only be lifted at both
carrying handles. Never reach under the
machine.
Take the weight of the machine into
account and use suitable loading aids
(lifters) if required.
Secure the machine and other machine
parts being transported (e.g. docking
station) on the load floor using fastening
materials (straps, ropes, etc.) of an
adequate size at the fastening points
described in this instruction manual.
( 20.)
When transporting the machine, always
observe regional legislation, especially
regarding load security and the transport
of objects on load floors.
Do not leave the battery inside a vehicle
and never expose it to direct sunlight.
Lithium-ion batteries must be treated with
special care during transport. In particular,
short-circuit protection must be ensured.
Only transport the battery in the robotic
mower.

6.6 Before initial operation

It must be ensured that all persons who
use the machine are familiar with the
instruction manual.
Carefully follow the instructions for

installing the docking station (

perimeter wire ( 11.).
The perimeter wire and the power cable
must be securely fastened to the ground
so that they do not present a tripping
12.1) and
89