Adapting The Programming; Automatic Mowing - Viking MI 632 M Gebrauchsanleitung

Inserting the control panel:
Stow the spiral cable (1) in the housing
compartment. Tilt the control panel
backwards slightly, insert the retainers (2)
in the recesses in the housing (3), then
press down the control panel at the front
and allow to engage.

15.3 Adapting the programming

The current programming can be seen in
the mowing plan or in the iMow app.
( 11.10)
The mowing plan is calculated based on
0478 131 9937 B - EN
the size of the mowing area during
installation or during the creation of a new
mowing plan.
The active times and the mowing
duration can be changed individually, the
required mowing operations themselves
are automatically distributed over the
possible active times. If required, several
mowing or charging operations can run
during an active time. If required, the edge
of the mowing area can be cut
automatically at regular intervals. (
Up to three different active times per day
are possible. ( 11.10)
If the robotic mower has to travel to
specific areas of the mowing area, starting
points must be defined. ( 11.8)
Under certain circumstances (e.g.
warm weather or generous time
window), not all the active times
may be necessary for optimal lawn
care.
Changing the active times using the
iMow app: ( 10.)
– Additional active times for further
mowing operations
– Adapting the time window, e.g. to
prevent mowing during the morning or
night.
– Omitting individual active times
because the mowing area is e.g. being
used for a party.
Extending the mowing duration using the
iMow app: ( 10.)
– There are areas which are not mown
sufficiently, e.g because the mowing
area has lots of corners.
– Intensive grass growth during the
growing period.
– Particularly dense lawn.
Reducing the mowing duration using the
iMow app: ( 10.)
– Reduced grass growth due to heat, cold
or dryness.
Creation of a new mowing plan with the
help of the iMow app: (
– The size of the mowing area has been
changed.
New installation:
10.)
– New location of the docking zone
– Initial operation on a new mowing area

15.4 Automatic mowing

● Switching on automatic mowing:
Automatic mowing can be switched on
and off using the iMow app.
● Machine active/inactive:
The machine can be set to "active" or
"inactive" on the control panel in the
Commands menu.
If automatic mode is switched on, the
machine must be set to "active" so that
it can work in collaboration with the
other machines to mow the mowing
area.
● Starting mowing operation:
The mowing operations are
automatically distributed between the
available active times. (
10.)
14.3)
147