Robacta Twin Professional Testing System - Testing Twin Robot Torch Necks; Preparing The Testing Unit - Fronius Robacta series Bedienungsanleitung

Robacta Twin Professional Testing System - Testing
Twin Robot Torch Necks
Preparing the
Testing Unit
Assembly positions on the base plate
Testing unit: Removing the Allen screw
Mounting the testing unit
The base plate of the Robacta Twin Profes-
sional testing system contains 5 possible
positions for mounting the testing unit.
For packaging reasons, the testing unit is
pre-mounted on the "0° kurz" [0° short]
mounting position when delivered.
Mount the testing unit in the correct position
on the base plate for the torch neck curva-
ture of the welding torch to be tested:
Remove the Allen screw on the testing
1
unit using an Allen key (6 mm)
Remove the testing unit
2
Screw the testing unit to the correct po-
3
sition on the base plate for the torch
neck that is to be tested
77