Robacta Complete System Testing System - Testing Complete Robot Welding Torch Systems; General; Preparing The Testing System - Fronius Robacta series Bedienungsanleitung

Robacta Complete System Testing System - Testing
Complete Robot Welding Torch Systems

General

With the Robacta Complete System testing system you can test complete robot welding
torch systems, from the torch neck to the shutoff box, for dimensional deviations.
The user is responsible for the setup and initial adjustment.
There are various options available for testing, for example:
-
-
-
-
Preparing the
1
Testing System
Assembly positions on the base plate
Securing the testing unit
Torch neck
Torch neck + hosepack
Torch neck + hosepack + adjusting clip
Torch neck + hosepack + adjusting clip + robot shutoff box
Check torch neck of the complete system using a suitable Robacta testing system
The base plate of the Robacta Complete
System testing system contains 6 possible
positions for mounting the testing unit.
For packaging reasons, the testing unit is
pre-mounted the wrong way round on the
0° mounting position when delivered.
Remove the Allen screw on the testing
2
unit using an Allen key (6 mm)
Remove the testing unit
3
Screw the testing unit to the correct po-
4
sition on the base plate for the torch
neck that is to be tested
79