22.9.1.1. Updating the BIOS under Dos
When booting into MS-DOS, do not start any network driver or memory management
programs such as EMM368 or HIMEN.
1. Boot into MS-DOS.
2. Create a RAM disk.
3. Copy CGUTLCMD.EXE and the current binary file to this RAM disk.
4. Start the update with the following command:
cgutlcmd bflash `name of the binary-file´ /c
The update is carried out without further confirmation and the computer is restarted.
After completing the update, the settings described below need to be configured in the
Bios Setup Utility menu.
Page
Exit
Main Setup Page
DLoG IPC 7/215
Item
<Load CMOS Defaults>
Save and Exit with <F10> <OK> No setting possible
Handbuch
Anhang F: BIOS
Setting
No setting possible
199