Ide Configuration Submenu - DLoG IPC 7 Handbuch

22.5.7. IDE Configuration Submenu

Feature
ATA/IDE
Configuration
►Primary IDE
Master
►Primary IDE
Slave
Hard Disk Write
Protect
IDE Detect
Time Out (s)
DLoG IPC 7/215
Options Description
Disabled Configure the integrated parallel and serial
Compatible ATA controllers.
Enhanced Disabled: Both controllers are disabled.
Compatible: Both controllers operate in
legacy or compatible mode.
Enhanced: Both controllers operate in
enhanced or native mode.
sub menu Reports type of connected IDE device.
sub menu Reports type of connected IDE device.
Disabled If enabled, protects the hard drive from
Enabled being erased.
Disabled allows the hard drive to be used
normally. Read, write and erase functions
can be performed to the disk.
0, 5, 10, ... 30, Set this option to stop the BIOS from
35 searching for IDE devices within the
specified number of seconds. Basically, this
allows you to fine-tune the settings to allow
for faster boot times. Adjust this setting until
a suitable timing can be found that will allow
for all IDE disk drives that are attached to be
detected.
Handbuch
Anhang F: BIOS
181