Inhaltsverzeichnis
Werbung
22.5.10.
Remote Access Configuration Submenu
Feature
Remote
Access
Serial Port
Number
Serial Port
Mode
Flow Control
Redirection
After BIOS
POST
DLoG IPC 7/215
Options
Description
Disabled
Enable/Disable the BIOS remote access
Enabled
feature.
Note : If the systems serial ports are
disabled in the 'I/O Interface Configuration'
submenu, then Serial Redirection is
disabled and 'Remote Access Configuration'
menu is unavailable to the users.
COM1
Select the serial port you want to use for
COM2
console redirection.
Note: Only enabled serial ports are
presented as an option.
115200 8,n,1
Select the baud rate (transmitted bits per
57600 8,n,1
second) you want the serial port to use for
19200 8,n,1
console redirection.
Note: The terminal program used with Serial
Redirection must be set to use exact the
same set of communication parameters.
None
Select the flow control for Serial Redirection.
Hardware
Software
Disabled
With Disabled Serial Redirection
Boot Loader
functionality is disabled at the end of BIOS
Always
POST.
If set to Always , all resources and interrupts
associated with Serial Redirection are
protected and not released to DOS. This
option lets Serial Redirection permanently
reside at base memory which allows the
DOS console to be redirected. Note, that
graphics output (VGA, SVGA, etc) from
DOS programs is not redirected !
If set to Boot loader , Serial Redirection is
active during the OS boot loader process.
This allows boot status messages to be
Handbuch
Anhang F: BIOS
187
Werbung
Inhaltsverzeichnis
