Horn; Electric Lift Switch; Plastic Loadbed - E-Z-GO MPT 800 Bedienungs- Und Wartungshandbuch

Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
With the switch in 'TOW/MAINTENANCE' position:
•
the controller is deactivated
•
the electronic braking system is deactivated which
allows the vehicle to be towed or roll freely
•
the warning beeper is deactivated
With the switch in 'RUN' position:
•
the controller is activated
•
the electronic braking system and warning beeper
features are activated
PDS vehicles operate only in the 'RUN' position.
The PDS is a low power consumption unit but it will drain
the vehicle batteries over a period of time. If the vehicle
is to be stored for a prolonged period of time, the PDS
should be disconnected from the batteries. (Refer to Pro-
longed Storage on page 24)

HORN

The horn is operated by pushing the horn button located
on the floor to the left of the brake pedal (Ref Fig. 9 on
page 5).

ELECTRIC LIFT SWITCH

The optional electric lift switch is located on the seat
panel (Ref Fig. 12 on page 6). See 'Electric Lift Bed
Operation' for operating information.
Horn
Ref Hor 1
Fig. 9 Horn Button
OPERATION AND SERVICE INFORMATION

PLASTIC LOADBED

The manual lift bed is the standard bed for the vehicle.
The bed may be equipped with an optional electric lift
switch.
Failure to follow these instructions may result in
personal injury, damage the vehicle and/or
cause the vehicle to tip over. Operate the vehi-
cle with awareness of the load. Read, under-
stand and follow the Danger label affixed to the
front of the loadbed.
Do not permit anyone to ride in the bed.
Before operating, check to ensure no one is
behind the vehicle.
A loadbed warning label is affixed to the inside front of
the bed (see Appendix A). This label must be understood
and observed at all times for safe operation of the vehi-
cle. See the loadbed warning label for maximum load.
The load must be positioned in the bed as far forward as
possible, distributed in such a way that its center of grav-
ity must not be higher than height noted on label, and
securely fastened down. Failure to follow these instruc-
tions may result in severe personal injury, damage the
vehicle and/or cause the vehicle to tip over. Operate the
vehicle with awareness of the load.
Do not permit anyone to ride in the bed.
Do not drive the vehicle with the loadbed raised or with
the tailgate unsupported.
When using the electric lift, be sure to avoid backing up
to the edge of a drop off, such as a loading dock or
ravine. A misjudgment of distance or an unstable surface
could result in the vehicle falling backwards.
Before operating, check to ensure no one is behind the
vehicle.
Never fill a gas can in the bed of a vehicle.
Static discharge could ignite gasoline vapor
and cause an explosion.
Always place a gas can on the ground before filling.
Never fill a gas can in the bed of the vehicle. Static elec-
tricity is built up during the fueling process and could dis-
charge causing the gasoline vapor to ignite.
Owner's Manual and Service Guide
Page 5